D-CON Delta Pro Final Finishing Polishing Pad White

The D-CON Delta Pro Final Finishing polishing pad in white is made from ultra soft foam for the last finishing step after polishing. The slightly rounded edges protect trim and plastic parts while the pad spins, and the cooling hole in the centre improves airflow so the foam heats up less during longer sessions. Attach the pad by its hook-and-loop backing to the plate of a DA polisher (dual action). Use it with a wax, glaze or fine polish to leave a deep gloss without further correction. Choose the size that fits your backing plate, from 35-45mm for small, hard-to-reach spots to 150mm for large panel surfaces.

What's inside

1 D-CON Delta Pro Final Finishing polishing pad in white, ultra soft foam with cooling hole and hook-and-loop backing.

Why this product

• Ultra soft foam for the finishing step after polishing

• Cooling hole in the centre improves airflow while spinning

• Slightly rounded edges protect trim and plastic parts

• Hook-and-loop attachment to the backing plate of a DA polisher

• Available from 35-45mm to 150mm for every backing plate

How to use

1. Attach the pad centred on the backing plate of your polisher (Make sure the hook-and-loop sits flat and even)

2. Apply a small amount of wax or glaze and spread at low speed (Then work at medium speed until the product is spread evenly)

3. Wipe the section with a microfibre towel and check the gloss (For uneven gloss, repeat the section with a light extra pass)

Watch the video

Finish the gloss with the Shiny Garage Paint Glaze and wipe down with the D-CON Max microfibre towel.