Krauss Replacement IR Lamp for Speed Dry 100/200/300

This Krauss replacement lamp brings your Speed Dry paint dryer back to full power and fits the 100, 200 and 300 models, handy if you run several dryers in the workshop. The short wave radiation penetrates primer, base coat, clear coat and any glass coatings, curing them from the inside out. That prevents blistering and speeds up drying and curing, resulting in an even, glossy finish. The lamp is made from pure quartz glass for consistent heat transfer, rated at 1 x 1100W over a drying area of 1200 x 1000mm.

What's inside

1x Krauss replacement IR lamp for Speed Dry 100/200/300

Why this product

• 1 x 1100W power output for fast and thorough drying

• Universal fit for Speed Dry 100, 200 and 300

• Drying area of 1200 x 1000mm for larger panels

• Pure quartz glass for even heat transfer across the surface

• Prevents blistering by curing from the inside out

How to use

1. Switch off the Speed Dry dryer and let it cool completely before replacing the lamp.

2. Remove the old or broken infrared lamp carefully from its socket.

3. Carefully place the new Krauss lamp in the exact same position as the old one.

4. Test the dryer at low power before running it fully on your next job.

Pair the replacement lamp with Mirka Abranet Sanding Net P400 and Bilt-Hamber Flat Face Primer Filler for thorough prep before drying.