Sundstrom SR900 Basic Set Half Mask with P3 Filter

The Sundstrom SR900 Basic Set is a complete half mask kit, ready to use straight away for professional and demanding work. The set includes the SR900 mask with the SR510 P3 particle filter, which filters 99.997% of fine dust, splashes, bacteria, viruses and even asbestos fibers. SR221 prefilters catch coarser particles, extending the life of the main filter, while the included prefilter holder makes swapping quick. The mask itself is made from soft thermoplastic elastomer (TPE) with FDA approved materials, and the adjustable V-shaped head harness gives you a secure, comfortable seal on your face. Two large exhalation valves minimize condensation and breathing resistance, even during extended wear. The set is suited for use when applying ceramic, quartz and graphene coatings, and comes complete with a cleaning wipe and storage box, so your mask stays clean and protected between uses.

What's inside

1x SR900 half mask (size M), 1x SR510 P3 particle filter (99.997% efficiency), SR221 prefilters, 1x prefilter holder, 1x cleaning wipe and 1x storage box.

Why this product

• SR510 P3 particle filter with 99.997% filtration efficiency against fine dust, splashes, bacteria, viruses, asbestos fibers and even radioactive particles

• SR221 prefilters catch coarser particles and significantly extend the life of the main filter

• Soft thermoplastic elastomer (TPE) with FDA approved materials for long-lasting wearing comfort on your face

• Adjustable V-shaped head harness and ergonomic design give you a secure, airtight seal

• Two large exhalation valves minimize breathing resistance and condensation, even during intensive professional use

• Comes complete with prefilter holder, cleaning wipe and storage box, ready to use for coating work

How to use

1. Check that the P3 filter and prefilters are correctly fitted onto the holder (A misfitted filter causes leakage and reduced protection)

2. Place the mask over your nose and mouth and pull the V-shaped harness snug for an airtight fit (Make sure the harness sits symmetrically so pressure is spread evenly across your face)

3. Check the seal by briefly covering the filter with your hand and inhaling (If you feel air entering along the mask edges, readjust the head harness)

4. Store the mask clean in the included storage box after use (This keeps the mask protected from dust and damage until your next job)

Top up your set with an SR900 replacement filter and safety glasses for complete protection on every coating job.