D-CON W-APS Wasapplicator Rood

A good wax or sealant layer does not require a lot of product, but it does require an applicator that distributes it evenly. The D-CON W-APS Foam Applicator features dense, fine-cell foam that absorbs minimal product. Nearly everything you put on it ends up on the paint, in a thin, even layer. Cheaper alternatives with open pores soak up half your wax before you even begin. The soft texture is safe on paint and clearcoat, with no scratch risk. Use the red colour as a marker: red for wax, keep a different colour for sealant or coating.

What's inside

1 D-CON W-APS Foam Applicator in red, dense fine-cell foam for wax and sealant application

Why this product

• Dense, fine-cell foam: absorbs minimal product, virtually everything applied ends up on the paint surface

• Even distribution: thin, consistent wax or sealant layer without pressure points or uneven patches

• Soft texture: no scratch risk on paint or clearcoat, safe on all painted surfaces

• Red colour coding: easily distinguished from applicators used for other product types

How to use

1. Apply a small amount of wax or sealant to the applicator (Less is more. A thin layer roughly the size of a coin is enough for one panel.)

2. Work the product in with light, circular motions on the painted surface (Use minimal pressure, the foam distributes the product evenly on its own.)

3. Allow the product to cure according to the product instructions and remove with a microfibre towel (Follow the cure time of the wax or sealant. Use a clean microfibre towel to buff off.)

Pair the W-APS Applicator with D-CON Vanilla Cream Carnauba Wax, D-CON Lightning Wet Coat Sealant and a D-CON Workhorse Microfibre Towel for a complete wax protocol.