D-CON Snow Foam Lance V2

The D-CON Snow Foam Lance V2 features an 800 ml tank and is tuned to produce an extra-thick, clinging foam layer. Attach it to your pressure washer, fill the tank with snow foam shampoo, and blanket the car completely, from bumper to roof. The foam loosens dirt and fine particles before you touch the paint, reducing scratch risk. The bottle is replaceable (HOL_FL_HP_2.1) so you don't need to replace the whole lance when it wears out.

What's inside

1 D-CON Snow Foam Lance V2 with 800 ml tank

Why this product

• 800 ml tank: enough for one full wash session without refilling

• Extra-thick clinging foam layer lifts dirt before any contact with the paint

• Compatible with virtually all common pressure washers

• Replacement bottle (HOL_FL_HP_2.1) sold separately so the lance lasts longer

• Reduces scratch risk through the lubricating foam layer before hand washing

How to use

1. Connect the lance (Attach the V2 to the pressure washer via the connector thread. Check for leaks before starting.)

2. Fill the tank (Add snow foam shampoo and water to the 800 ml tank. A 1:7 to 1:10 ratio is a good starting point.)

3. Apply foam to the car (Hold the lance 30-50 cm away and work from bottom to top for even coverage.)

4. Dwell and rinse (3-5 minutes is enough dwell time to loosen dirt and particles. Rinse off before hand washing.)

Use the Snow Foam Lance V2 with D-CON Snow Foam Concentrate for maximum foam, or keep the V2 Replacement Bottle on hand for when the original wears out.