Tornador Spring

The Tornador Spring is the small mechanical part that restores trigger tension and responsiveness in your Tornador cleaning gun. Wear on the internal spring mechanism eventually causes a sluggish or jerky trigger, reducing control over airflow. This OEM spring installs without special tools and immediately restores smooth, consistent operation. A compact but essential spare part for keeping your Tornador Classic or Black in top condition for professional detailing work. Replacing it yourself takes just a few minutes and saves the cost of a full trigger replacement or a new gun.

What's inside

1x Tornador Spring, an original OEM part for the Tornador Classic and Black cleaning guns.

Why this product

• Restores trigger tension and responsiveness in your Tornador gun immediately, back to factory level

• Prevents failures and jerky operation caused by a worn internal spring mechanism

• Install it yourself in minutes, no special tools required

• OEM quality built to original Tornador specifications for lasting durability and reliability

• Essential for consistent airflow and optimal performance on every detailing job

How to use

1. Disconnect the air supply and remove the trigger housing from your Tornador gun.

2. Take out the old, worn spring from the mechanism and check the housing for dirt or wear.

3. Place the new Tornador Spring in the exact same position and click the mechanism firmly back together.

4. Close the housing carefully and test the trigger for smooth, even operation before you use the gun again.

Pair your refreshed trigger with a concentrated Koch-Chemie MZR all-purpose cleaner and a Chemical Guys microfiber towel for a complete interior and engine bay detail.