Tornador O-Ring

This Tornador O-Ring creates an airtight, leak-free connection at the fitting points of your Tornador cleaning gun. O-rings sit in several places inside the gun: at the air connection, around the nozzle, and at the bottle coupling, each with its own size. That is why this O-ring is available in 2x1 mm, 3.5x1.5 mm and 9x2 mm, so you pick the exact size that matches your worn one. Rubber ages from exposure to compressed air and cleaning chemicals, turning hard and brittle over time and losing its seal. This genuine OEM part restores pressure and prevents leaks, without improvising with a generic O-ring that never fits quite right.

What's inside

1 genuine Tornador rubber O-ring, pick the correct size for your connection point when ordering.

Why this product

• Genuine Tornador OEM part for a guaranteed, precise exact fit

• Available in 3 sizes: 2x1 mm, 3.5x1.5 mm and 9x2 mm

• Prevents air leaks and pressure loss at every connection on your gun

• Replaced in seconds, no tools needed at all

How to use

1. Determine which size you need by measuring the old O-ring or comparing it to the fitting.

2. Carefully remove the worn O-ring from the groove.

3. Roll the new O-ring evenly over the fitting until it sits properly in the groove.

4. Connect the gun to your compressor and check that the connection is airtight.

Keep it handy for every job: refill your Kwazar Neptune 15L pressure sprayer and keep a Koch-Chemie MZR all-purpose cleaner within reach.