DNE MaksMaster SG2 PDR Lamp

The DNE MaksMaster SG2 is a professional inspection lamp for paintless dent repair (PDR). With 6 individually dimmable LED strips and a maximum output of 1220 lumens, it makes even the subtlest bodywork dents sharply visible. The telescopic SOFIT stand adjusts from 1170 to 1910 mm in height, so you can inspect the roof of a car as easily as the door sill area.

The arm tilts and rotates, letting you position the light pattern exactly where you need it on the dent you are working. The matte anti-glare diffuser produces soft shadows without distracting reflections. Power via the 12V cigarette lighter socket or direct crocodile clips on the battery makes the lamp usable in any workshop setup. The shock-resistant housing with rubber-edged surround and waterproof construction holds up in daily professional use.

What's inside

DNE MaksMaster SG2 PDR inspection lamp, 6 dimmable LED strips, telescopic SOFIT stand (1170-1910 mm), tiltable arm, matte diffuser, 12V cable with cigarette lighter and battery clamps.

Why this product

• 6 individually dimmable LED strips: dial in the shadow pattern that makes your dent most visible

• Up to 1220 lumens for clear, detailed bodywork analysis even in well-lit garages

• Stand adjusts from 1170 to 1910 mm so you reach roof to sill without awkward angles

• 12V power via cigarette lighter or direct battery clamps, ready in any working setup

• Waterproof housing with shock-resistant rubber surround for sustained professional use

How to use

1. Position the stand next to the bodywork panel to inspect (Extend the SOFIT stand to the needed height (1170-1910 mm). Angle the arm at 30-45 degrees to the surface for optimal shadow projection.)

2. Connect the lamp to a 12V power source (Use the cigarette lighter socket or clip directly to the battery. Switch the vehicle off to avoid power spikes.)

3. Dim the LED strips individually to the ideal shadow pattern (Switch the 6 strips on one by one and dim each until the dent appears as a clear dark line. Tilt the arm to refine the result.)

4. Keep the lamp in position as a reference during PDR work (Leave the lamp in place while working the dent. The light shows every push or pull result instantly.)

Pair the MaksMaster SG2 with the Etari Midiar PDR gas burner for thermal dent work, the Scangrip Nova UV-S for coating inspection after repair, and finish with the D-CON Fatty Orange drying towel after final cleaning.