Tornador Gasket Z-010 (28) / Z-020 (2)

This Tornador Gasket is the genuine rubber seal at position 28 on the Z-010 and position 2 on the Z-020. Contact with cleaning agents and compressed air makes rubber harden and shrink over time, so the housing no longer closes fully airtight. The result: pressure loss, reduced cleaning power, and sometimes fluid leaking along the seam. This genuine gasket restores the seal exactly as Tornador intended, without improvising with generic rubber rings that never quite fit. A simple swap that gets your gun back to full pressure when blowing out and cleaning your interior.

What's inside

1 genuine Tornador rubber gasket, sized exactly for position 28 on the Z-010 or position 2 on the Z-020.

Why this product

• Genuine Tornador OEM part for a guaranteed, precise exact fit

• Fits both the Z-010 (position 28) and Z-020 (position 2) perfectly

• Restores a fully airtight seal on your housing within minutes

• Prevents pressure loss and annoying fluid leaks during intensive use

How to use

1. Open the housing of your Tornador gun where the old gasket sits.

2. Remove the worn gasket and clean the groove of dirt and old rubber residue.

3. Seat the new gasket evenly in the groove and close the housing firmly.

4. Test the gun on your compressor and check that the seal is airtight.

Done fixing it? Move on to a Koch-Chemie MZR all-purpose cleaner and the ProElite Cockpit Oceanic interior dressing for the final part of your detailing session.