Grit Guard Emmerrooster

A scratch during the wash usually comes from one moment: the mitt going back into a dirty bucket. The Grit Guard Bucket Insert prevents that. Place the grid on the bottom of your bucket, rub your wash mitt over it after each pass, and the coarse grit stays separated. Four quadrant stabilizers calm the water so dirt sinks and stays at the bottom. Available in black, red, blue and silver, fitting buckets of 3 to 5 gallons (approx. 12-20 litres). Pair with the two-bucket wash method for full paint protection.

What's inside

1 Grit Guard Bucket Insert, fits 3 to 5 gallon buckets (approx. 12-20 litres), available in four colours

Why this product

• Four quadrant stabilizers: calm water and keep dirt at the bottom

• Fits 3-5 gallon buckets (approx. 12-20 litres): standard size

• Available in four colours: black, red, blue and silver

• Works with mitts, sponges and brushes: versatile across tools

How to use

1. Place the grid on the bottom of the bucket (The guard clips against the bucket walls. Make sure it sits firmly before you start washing.)

2. Use the two-bucket wash method (Bucket 1 = shampoo wash solution. Bucket 2 = clean rinse water. A grid in both buckets gives maximum protection.)

3. Rub the mitt or sponge over the grid after each panel (The grid separates grit and dirt from the mitt. The dirt sinks to the bottom and stays there thanks to the stabilizers.)

Pair the Grit Guard with the D-CON Ultra Clear Wash Bucket, a D-CON Chenille Wash Mitt and D-CON Mint Splash Shampoo for a complete wash setup.